View Full Version : Tube vice "sleeve"
jcecil
02-27-2012, 05:59 PM
Similar to what you would see on Infinite Irons I need just the sleeve how sales this product or even where I could get the material to make my own?
Administrator
02-27-2012, 06:03 PM
You may be able to just buy a cheap SS single flaired body jewlery tunnel. Cut a slit in it?
OwlsDen
02-27-2012, 06:08 PM
Or buy a 10$ china machine and desolder and remove the sleeve.
I think you want 10mm ss tubing with an 8mm diameter and a 1mm wall. You can find that on eBay or a plumbing shop.
Administrator
02-27-2012, 06:11 PM
Or buy a 10$ china machine and desolder and remove the sleeve.
I think you want 10mm ss tubing with an 8mm diameter and a 1mm wall. You can find that on eBay or a plumbing shop.
Good options as well. I have seen a similar fix mentioned once where the person posted something like "Commandeered a tunnel from the piercer at the shop"
nivek
02-27-2012, 06:47 PM
Single flared tunnels are like a buck or two from any jewellery supplier or a straight tunnel, even cheaper
http://www.ebay.com/itm/00g-10mm-Plain-Steel-Single-Flare-Tunnel-Ear-Plug-/280506975158
(http://www.ebay.com/itm/00g-10mm-Plain-Steel-Single-Flare-Tunnel-Ear-Plug-/280506975158)
Frosty
03-15-2012, 02:37 PM
i just get a piece of tubing from the hardware store and cut a bunch of em...
peter clements
03-15-2012, 03:00 PM
Is it what we would call a "Collett" ?
I personally dont like them on my machines and just cut them off. I'll take a look in my junk drawer to see if I have any. I'll just send them to you if you want them. pm me your address. I'll just throw them in an envelope and just send them snail mail.
jcecil
03-15-2012, 11:11 PM
I appreciate it CKJR I just cut off the old vice and bolted a new one on I have a 1" machine and didn't have enough vice to hold my tubes
Powered by vBulletin® Version 4.1.12 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.