Stigma Prodigy Woes

[crabink]

OK. Being new to rotary I opted to get the clip cord ad on for my Prodigy.. and when i put it on it broke the contact inside and obviously it won't run. Even though I was careful and followed the instructions I failed to stop at the correct depth based on felling for the resistance of the hidden contact inside because the tight allen screw was giving me resistance as well. So now it is just an RCA only machine unless they replace the motor and I try again. If they don't replace the motor so i can retry this clip cord add on I am going to sell it to an RCA user... I will most likely sell it for 550.00 with all the execenters and eat 150.00. I ran it with RCA and it works fine.. I don't want to switch back and forth from clip cord to RCA all the time. Maybe I will convert all my coils to RCA.. I don't know.. I am pissed the fuck off..

Why would they not create a design with it all contacts intact like the v3. I would have bought a halo but it was RCA only. I think maybe i will just buy 2 more RCA machines and see how that goes.

So.. for all of you guys adding the clip cord connection.. screw it is a short ways and run the machine periodically until it turns on and make sure you have the clip cord on the right way.. try both ways each time... When it goes on the give it a very small extra turn and the connection will be perfect.

Stigma should have a detailed video of how to do this because it's a pain in the ass, and it is going to cost them motors. I guarantee 1 in 4 people will fuck up their motor doing this.