I have that problem CONSTANTLY w/ only one machine, my Bizarre V2. My co-worker has one and has never had a problem w/ it. ??? I've tried everything too.
Results 1 to 10 of 22
Hybrid View
-
07-03-2012, 01:29 PM #1Senior Member
- Join Date
- Jun 2012
- Location
- Austin, TX
- Posts
- 243
- Post Thanks / Like
-
07-03-2012, 01:43 PM #2Machine Builder
- Join Date
- Dec 2010
- Location
- San Jose & Morgan Hill,CA
- Posts
- 4,133
- Post Thanks / Like
Try his needles(have him do his needle/bar bend), tubes & ink brands on yours to see if its the brands you use doing it.Also I would check to see how his motor/piston etc are lined up as compared to yours-maybe something is out of alignment.
Originally Posted by PAWNJOB
SSI -SUPER SLICK IRONS-top shelf custom coil machines
American Made Machines
[email protected]
https://www.facebook.com/evanstattooing
-
07-03-2012, 01:51 PM #3Knows Whats Up!
- Join Date
- Dec 2011
- Location
- UK..
- Posts
- 2,444
- Post Thanks / Like
Good advice,,,, Originally Posted by slicksteel
-
07-03-2012, 02:00 PM #4Senior Member
- Join Date
- Jun 2012
- Location
- Glasgow
- Posts
- 196
- Post Thanks / Like
It's only happened to me once and that was with my bizarre v2, I emailed stigma about it and 10 minutes later a very nice chap from Germany phoned the shop to talk me through stripping the machine and cleaning it properly, he then told me he thought the problem was too much bend on the needle bar making it ride the top of the tube, I've sinced changed wher I bend the bar to just at the solder a slight bend down and then again one finger space back an it's never happened since
Reply With Quote
Bookmarks