Spektra Halo feedback thread

[vodu]

Gaston, do you have a CPS/Volt chart of spektra halo?

[fkirons]

Gaston, do you have a CPS/Volt chart of spektra halo?

CPS or Hertz do not apply to rotaries as the circuit is constant. SO whatever the machine throws at you ignore it but you should see cycle being close to 99 or 0.
Regarding voltage, I say anywhere from 5-12V. 8.5 being the happy medium. enjoy!

[vodu]

[QUOTE=fkirons;77482]CPS or Hertz do not apply to rotaries as the circuit is constant. SO whatever the machine throws at you ignore it but you should see cycle being close to 99 or 0.
Regarding voltage, I say anywhere from 5-12V. 8.5 being the happy medium. enjoy![/QUOTE

well, i´m curious to know for example, how many strokes per second it goes by each 1 volt, between 8 - 12, the cycles get faster as more volts you put on P.S. right? for example, for lining lots of artists prefer like 120cps, for packing 80-90 and shading between both....like, it´s good to know how many volts you need to achieve in halo to do the same as the old coils each one use....for example, if I use my liner at 120 cps what is needed to put in the PS for the same results?